Family-owned. Faith-driven. Here to help.Serving Mebane & the North Carolina Piedmont
Called to Repair · North Carolina

Appliance service around your neighborhood

Explore 620 preserved service records across our communities.

Preserved service history

We serviced a

Whirlpool Dryer

Model WED6620HC1 · Near Jamestown, North Carolina 27282

replaced idler pulley and sent full report to AHS. Job complete

Tim · 07/02/2026

We serviced a

Kenmore DISHWASHER

Model 665.14545N711 · Near High Point, North Carolina 27265

Fixed Filling issue with water inlet valve and test unit and everything tested out okay. Job complete

Tim · 07/02/2026

We serviced a

GE Dishwasher

Model GDF530PSMOSS · Near Durham, North Carolina 27703

Installed new display board and tested the unit. I found no further issues. Job completed. During diagnostics, found the unit had power coming in, but would not power up. Found the PCB to be faulty. After installing the new PCB, I still had no power to the UI. I found that the UI was the initial issue that I failed to find. There is a short in the UI board. We will need to order a new UI board and put the PCB in stock.

Mike · 07/02/2026

We serviced a

Samsung Cooktop

Model SAMSUNG · Near Pleasant Garden, North Carolina 27313

replaced both regulator switches and tested unit and everything tested out okay. Job complete

Tim · 07/02/2026

We serviced a

Frigidaire Refrigerator

Model LFSS2612TF0 · Near Durham, North Carolina 27701

During inspection, I tried to fill a glass with water. The unit would “hum” but not deliver any water. I found that the water was turned off under the sink. After turning the water on, I again tried to fill a glass with water. The water started leaking inside and out onto the floor. I found the filter housing is cracked and creating the leak.

I told the tenant they would need to replace the water filter and that would remedy the issue. If not, call us back.

Job completed.

Mike · 07/02/2026

We serviced a

Whirlpool MICROWAVE

Model MH7135XEQ0 · Near Browns Summit, North Carolina 27214

customers complaint is that the door handle broke off. during inspection I found that the door handle broke off due to the fact that is over 30 years old and it was completely worn down from normal use. this is normal wear and tear. the door handle is showing completely discontinued. reporting all findings to customers Home warranty

Tim · 07/02/2026

We serviced a

Whirlpool Dishwasher

Model WDF540PADM3 · Near Durham, North Carolina 27712

Insatlled new PCB and tested with customer present. Unit is operating normally.
Job completed.,During diagnostics, I found that the unit would fill and drain, but would not circulate any water. I tested and found I had no power at the circulation pump. Bad PCB.

Mike · 07/02/2026

We serviced a

Electrolux Dryer

Model EIMED55IRR0 · Near Greensboro, North Carolina 27406

replaced moisture sensor and tested unit and everything tested out okay. Job complete

Tim · 07/01/2026

We serviced a

Whirlpool Range,Dishwasher

Model WFE505W0HS1,WDTA50SAHZ0 · Near Greensboro, North Carolina 27405

Replaced controls on Range and dishwasher and everything tested out okay. Job complete, customers complaint is that the dishwasher would not come on at all and that when operating for range for the initial big cycle it would not cancel after starting. found a broken wire underneath the dishwasher and repaired it however the dishwasher is still having control board issues along with some plumbing problems as well. dishwasher is not getting water and the touchpad is not responding appropriately and the control is acting up. customer will need a new touchpad and main control for the dishwasher and a main control for the range to resolve all issues. customer reaching out to plumber fix the water issue.

Tim · 07/01/2026

We serviced a

Lg Washer

Model WT5101HV · Near Durham, North Carolina 27713

Installed all new dampners. Reset and tested the unit and found no further issues.
Job completed. During diagnostics, I found I could push the tub done to the floor with my hand very easily. Dampners are worn out causing the imbalance issue.
Had to order the parts. couldn’t match a set that was on the truck.

Mike · 07/01/2026

We serviced a

Lg Refrigerator

Model LFXC22596S-01 · Near Graham, North Carolina 27253

We have completed a basic repair on your refrigerator to address the issue of insufficient ice production, which you previously reported. During this service, we installed the necessary part (L-G MJX61892901) to enhance the ice-making functionality. Customers complaint is that the refrigerator was making ice too slowly again. After diagnosis, I found the new ice maker motor in test mode still functioning perfectly; however, the ice maker was not getting enough water pressure during its fill cycle from the inlet valve assembly. The inlet valve that we got was not for the ice maker. Apparently, there are three separate valves. Ordering the correct valve.

Tim · 07/01/2026

We serviced a

GE Washer

Model GUD27ESSM1WW · Near Graham, North Carolina 27253

During diagnostics, I found that the inlet water valve is leaking water. The bigger issue I found, was the transmission is leaking all over the belt. At that point, I told the customer the transmission would need to be replaced.
Customer is going to buy another unit.
Job completed.

Mike · 07/01/2026