Explore 620 preserved service records across our communities.
Preserved service history
Kenmore Oven Range
replaced PCB and tested unit and everything tested out okay. job complete,customer needs new pcb
Lg WASHER
main PCB has back shorted into the display unit. not cost effective to repair. Recommended replacement. job complete
Maytag Washer
replaced drain hose on washer and fixed suspension rods. Job complete
Samsung Dryer
Installed new PCB. Tested unit and found no further issues.
Job completed.
During diagnostics, I found the unit to be unplugged on arrival. As soon as I plugged the unit in, the unit started up. The display panel was not even lit up.
Stuck relay on the PCB.
Samsung Microwave
adjusted latch assembly and test unit and everything tested out okay. job complete
GE Refrigerator
Insatlled new dampner fan and reset the unit. Testsd unit and found it to be operating normally. Told the customer to allow 24-48 hours for the unit to get back to normal operation temperature.
Job completed. During diagnostics, I found that the refrigerator compartment is warm while the freezer is working fine. I did not feel any cold air coming from the back panel.
I put the unit into Service Mode to check the dampner assembly. When I selected the dampner assembly test, I heard a “popping” noise coming from the lower back panel.
Dampner assembly is stuck closed.
GE,Whirlpool Wall Oven,Washer
replaced. bake element on customers range and reset the washer control board on the washer and tested both units and both units tested out okay. job complete
Whirlpool WASHER
customers complaint is that the washer would not start. fixed burned up wiring to washer and testing unit and everything tested out okay. Job complete
Lg Dryer
Found breaker was tripped. reset breaker and everything tested out okay. Job complete
Whirlpool Washer
Customers complaint is that the washer would not stop draining. Replaced main PCB and tested unit and everything tested out okay. Job complete
GE Dishwasher
During testing, I found the unit is cycling on and off, over and over again. I found the new board is getting very hot. I believe there is a short coming from the circulation pump. Custoker said the unit was running good for a couple of days, then it started doing tha same thing. AHS has decided to replace the unit due to the cost of replacing the extra parts. Job completed. During diagnostics, I found that Inhad no power to the circulation pump until I tapped on the PCB. Also, the lower spray arm is coming apart on the ends, and is hitting the heating element. Installed parts. Tested unit and found no further issues. Job completed.
Samsung Wall Oven
adjusted igniter and cleaned out gas tubing and tested the unit five times and everything ignited properly just fine. Job complete