Whirlpool Range
Whirlpool Range
Customer complaint: when she turn it on it gets much hotter than she set the temp to. asking for service. Initial visit (Nov 18) — Mike S: Reported concern The oven was evaluated for its heating performance. The customer stated that it has worked normally during her last two uses. Assessment The oven was set to 350°F and monitored for 20 minutes using two temperature sensors placed in the cavity. The unit heated during this test. In service mode, fault code AF 6E1 was found stored in memory. This code indicates an over-temperature condition, meaning the oven at some point exceeded its expected temperature range. This type of fault is most often caused by a failing control board (PCB) or a relay on the PCB sticking in the on position. A stuck relay can keep a heating element energized after it should shut off. Because the oven heated normally during the test, the condition appears to be intermittent. Next steps The technician recommends replacing the control board (PCB) and the oven temperature sensor together. Replacing both is intended to address the most likely causes of the over-temperature code. Confirm compatible part numbers for this model before ordering.
