Family-owned. Faith-driven. Here to help.Serving Mebane & the North Carolina Piedmont
Called to Repair · North Carolina

Kenmore Top-Load Washer

We serviced a

Kenmore Top-Load Washer

Gibsonville, NC 27249

Kenmore Top-Load Washer · Model 110.23822100

Customer complaint: Washer – is not pulling the water out of the clothes completely Dryer – is not heating. Initial visit (Nov 12) — Tim B: Customer mentioned the washer is not spinning like it used to. I checked out the washer and inspected the clutch and noticed that the clutch had oil on it from the transmission and was slipping. During further testing I heard some gears in the transmission slipping as well. This would require a new transmission which comes with a brand new clutch. However these transmissions have been rebuilt and have a malfunction to them to where they start making a loud screeching noise after installing. I do not advise this repair due to cost and not being able to get the original transmission.

Completed

GE Dryer · Model DBLR333ET0WW

Customer complaint: Washer – is not pulling the water out of the clothes completely Dryer – is not heating. Initial visit (Nov 12) — Tim B: During my diagnosis on the dryer I found the customer's heating coils completely shorted out as well as the front bearing and rear bearing falling apart. Customer's knob selection is also coming off but there are other knobs the customer can use to get by that can be switched out for the main selecting timer switch. This is a 20 plus year old unit and will require quite a few parts to get this thing running like a new again. Return visit (Nov 17) — Tim B: Replaced all parts to the dryer and tested unit and everything tested out okay job complete. Parts installed: WE11X10007C, SUPT FRT BRG, DRYER DRUM FRONT SLIDE BEARING, DRYER DRUM BEARING. Outcome: Repaired.

  • WE11X10007C (WE11X10007C) — Installed
  • SUPT FRT BRG (WE03X0077) — Installed
  • DRYER DRUM FRONT SLIDE BEARING (WE03X0087) — Installed
  • DRYER DRUM BEARING (WE03X0075) — Installed

Completed

Tim B · 2026-11-17 · Job completed