Explore 282 preserved service records across our communities.
Preserved service history
Whirlpool Dryer
During inspection, I found that the motor pulley broke, which also caused the drum belt to break.
I installed a new motor pulley and drum belt.
Tested unit and found it to be operating normally.
Job completed.
Frigidaire Dryer
Installed new start switch and tested the unit. Unit is operating normally.
During inspection, I found that for the unit to work, you have to hold down the “start” switch.
Bad start switch.
Job completed.
Amana Dishwasher
During testing, I could not verify the customers complaint. I started a cycle in front of the customer and the unit functioned normally. I tried 4 different cycles and the unit operated normally. This could be an intermittent issue. Job completed.
Kitchenaid DISHWASHER
During inspection, I noticed that someone has been inside the unit previously. The door was not correctly put back together. Also, the metal bracket that holds the PCB and door switch has been bent to the point where it will also need replacing. The PCB shorted out and fried the board. Both door panels are bent and are missing screws as well. First American is going to replace the unit.
Lg Dryer
Installed new rollers and tested unit. Unit is operating normally.
Job completed. ,During inspection, I found two of the drum rollers have failed.
Amana Dishwasher
Customer did not want us to repair the unit. He sent a text message to not trespass on his property.
Tim has had the WO transferred.
Samsung Range,Microwave
Installed new oven door gasket.
No further issues found.
Job completed.
Microwave-Door assembly is broken where the door connects to the hinge. The entire door assembly will need to be replaced. AHS is going to try and find the door.
Range-Oven door seal is non-serviceable and will need to be replaced. AHS has approved the repair.
Lg Washer
Installed new sensor and tested unit. Unit is operating normally now.
Job completed.
Maytag Washer
During testing, I found I had little to no water coming into the unit on a “Quick Wash” cycle. I found the inlet water valve assembly is sticking.
Installed new water inlet valve. Tested the unit and found no further issues.
Job completed.
Samsung Washer
During testing, I could not verify the customers complaint. I pulled the top and rear panels off to visually inspect for any damage. There were no codes when I put the unit into “Test Mode”. I did find that the drain hose was shoved further down into the drain pipe than it should be. I repositioned the drain hose. Advise customer to call us back if the issue persist. Job completed.
Whirlpool Refrigerator
During inspection, I found ice in the bottom of the freezer section. I found that the drain tube was clogged. I was able to clean out the drain tube and restore natural operation of the unit. Job completed.
Kitchenaid Microwave Wall Oven Combo
During testing, I found several issues with this unit. Customer told me on arrival, the microwave has not worked for five years. I disassembled the unit and started testing. I found the microwave transformer has been humming and got really hot. This in turn has caused the PCB to get hot and short out. Also, door latch mechanism for the oven is faulting to “Locked” when the unit is not locked. The microwave door also is not secured shot and easily falls open. This will be a rebuild because of the age of the unit.