Explore 282 preserved service records across our communities.
Preserved service history
Frigidaire MICROWAVE
Installed new parts and tested the unit. Unit is operating normally again.
Job completed.
Whirlpool Oven Range
I installed all new parts. Tested unit and found it to be operating normally.
Job completed. ,During testing, I found an error code.
F1E0-Board failure.
The unit will get to temperature, but will not maintain the temperature over time. Also, oven door seal is damaged due to age.
First American has approved the repair and is supplying the parts.
Samsung Range
I installed new parts and tested the unit.
No further issues found.
Job completed.
Bosch Dishwasher
During inspection, I found that the drain pump had come off allowing the leak. The pump was damaged by water and had to be replaced again under warranty.
I installed new pump and tested. no further issues found.
Job completed.
Kitchenaid Dishwasher
Kenmore Washer
During testing. I found the unit would not spin or agitate. I found the motor/transmission couple had failed. I installed a new coupler and tested the unit. Unit is operating normally. Job completed.
Whirlpool,GE Dryer,Cooktop
Insatlled all new parts and tested units. No further issues found.
Jobs completed.
Range-During inspection, I found that the F/L infinite switch has failed not allowing power to the element.
Dryer-During inspection, I found the belt tensioner, drum belt and rear drum seal failing is contributing to the drum not spinning.
Retrieved burner switch from range to be sent off for repair.
GE Dryer
I installed new timer. Tested unit and found it to be operating normally.
Job competed. ,During diagnostics, I found the timer has started to lock up. We will need to replace the timer to remedy the issue.
Samsung Washer
During testing, I found I could push the wash basket down very easily by hand. Bad shocks.
I installed new shocks. Tested unit and found it to be working normally.
Job completed.
GE Cooktop
I installed new PCB and tested the unit. I found no further issues.
During testing, I found that the unit would not power up. I checked and had voltage coming into the motherboard. However, when visually checking the board, I found a spot on it that has shorted out. I attached a picture of the area.
Customer wants to think on the repair.
Lg,Ge Profile Washer,Microwave,Dishwasher
Installed new PCB for the microwave. Testwd unit and found no further issues.
Job completed,Microwave-Switches and switch holder is bad. Will need to replace all the door switches and door switch holder assembly.
Dishwasher-The trim piece that goes over the control panel has broken. This is allowing foreign contaminants to get into the control display.
Washer-The unit moves a lot when loaded up and is on full spin. All shocks are worn and need to be replaced.
AHS has approved all the repairs and will be supplying all the parts. Please leave 3-hours for this job since there are 3 appliances to repair.